Product Info

    Leading Energy Saving Company

 
Power Drain Trap(pneumatic)
  • Float type(WRDT-500)
  • Float High Pressure(WRDT-500HS)
  • Float+Ball valve(WRDT-1000,2000)
  • Power Drain Trap(Electric)
  • Timer type(WRET-08,15)
  • Timer+Ball valve(WRMT-SERIES)
  • Sensor+Motorized valve(WRET-1500,3000)
  • High capacity(WRET-5000)
  • Reciprocating compressor(WRCT-08)
  • Reciprocating compressor(WRCT-08)
  • Attachable Valve Strainer(WRST-SERIES)
  • Attachable Valve Strainer(WRST-SERIES)
  • EXHAUST MUFFLER(ALWITCO, USA)
  • EXHAUST MUFFLER(ALWITCO, USA)
  • DEWPOINT METER(Shawmeters.UK)
  • DEWPOINT METER(Shawmeters.UK)
  • Air Filter Element(WRE-SERIES)
  • Air Filter Element(WRE-SERIES)

  • Float type(WRDT-500)

      ADVANTAGES

      1. High reliable working
      2. Manual discharge valve is sticked.
      3. No loss of compressed air
      4. Optimum determination of float location
      5. Easy maintenance
      6. Visible working status
      7. No need electric connection
      8. Easy installation

      APPLICATIONS

      1. AIR COMPRESSOR
      2. INTER COOLER
      3. AFTER COOLER
      4. SEPARATOR
      5. ECEIVER TANK
      6. AIR FILTER
      7. REFRIGERATED AIR DRYER
      8. OTHER PIPES WHERE CONDENSED WATER FORMED

      OPERATING PRINCIPLE

      INSTALLATION1

      1. Install when the condensed water outlet is higher than drain trap.
      1) Install Shut off Valve & Strainer first and install Trap lower area.
      2) Use the valve sticked strainer which is easy to clean
      3) Connect Outlet
      4) Open the manual valve and check if the compressed air and condensed water is flowed.

      INSTALLATION2

      2. Install when the condensed water outlet is lower than drain trap.
      1) Install Shut off Valve & Strainer first and install Trap by using Inlet.
      2) Connect Balance Line in the upper portion.If the Balance Line connection is difficult,install the valve and open slightly.
      3) Connect Outlet
      4) Open the manual valve and check if the compressed air and condensed water is flowed.

      WRDT-500 Drawing / Spec.

      SPECIFICATIONS
      Woring Temperature2 ~ 70℃
      Woring Pressure0.1 ~ 9.9kgf/㎠
      Maximum Capacity120Liter/hr
      AIR COMP.100HP
      INLETPT1/2" Up & Down2 point
      OUTLETPT 3/8"
      OPTIONY-strainer with cleaning valve